Sharp LL-T1610W, Руководство по обслуживанию, Страница: 6 / 33

CHAPTER 2. CONNECTION, ADJUSTMENT, OPERATION AND FUNCTIONS
1. CONNECTING THE MONITOR AND
TURNING THE MONITOR ON AND OFF
1-1. CONNECTING THE MONITOR TO A POWER
SOURCE
Use only the AC adapter and power cord supplied.
Notes:
•
Do not overly bend the cable or add extension cords as
this could lead to malfunction.
•
Do not remove the label next to the power-input terminal.
Also do not touch the switch covered by the label.
1. Remove the rear cover.
2. Remove the stand cover.
As in the diagram below, place two fingers on the stand cover and
while pushing the section
, pull it forwards .
3. Remove the adapter cover.
While pushing the section , pull it forwards and off .
4. Connect the AC adapter to the monitor’s power terminal, and
connect the power cord to the AC adapter.
5. Place the AC adapter inside the stand.
Wind the AC adapter cable and place it in the right-hand end of
the stand
.
Place the AC adapter inside . When doing this be careful not
to place the AC adapter on top of the cable as this will make it
difficult to replace the adapter cover.
Run the AC adapter cable between the AC adapter and the stand
.
6. Replace the adapter cover.
Rear cover
1
1
2
2
1
CAUTION!
Be careful not to
cut or jam your
fingers.
Stand cover
3
4
Adapter cover
Power cord
AC adapter
Run cord
through hole
6
7
5
8
Note: Take care not bend
or twist the cord
Run the AC adapter
cord through here.
Run the powerr cord through here.