Sharp FU-800-J, Руководство по эксплуатации

Страница: 10 / 28

INSTALLATION
E-8
NOTE
• The anti-toppling kit must be attached to en-
sure safety.
INSTRUCTIONS
• Where the back of the air purifier is closest to
the wall, a mark is likely to result after a while,
so it is recommended that a protective vinyl
sheet or suchlike be attached to the wall.
• Please select a strong site to install the sys-
tem, such as beside a stable pillar and sash
bar.
• Please contact professionals for installation on
weak partitions or concrete wall.
PREPARATION
1
Remove the two small screws from the
Main unit, and
reattach with the
two Chains
2
Decide on the installation position.
Please ensure a gap from the back, left and right
walls as indicated below.
3
Decide on an appropriate chain length,
and cut the Chain to the required length
using pliers or
suchlike.
IF THE PILLAR IS NARROW
Chain length
should be
decided to
enable setting
as shown in
the illustration.
4
Attach the Clasp to the Chain.
1
Open the Clasp, and in-
sert the last sphere on
the chain through the
hole.
2
Slide the sphere to the
end, and close the
Clasp.
Clasp
Spring washer
Small screw
10 cm or more
60 cm or more
60 cm or more
10 cm or more
Cut the chain to the
appropriate length.
Required length
Pillar
10 cm or
more
ANTI-TOPPLING KIT
Chains
(with a clasp at one end)
(30cmX2)
Clasps
(X2)
Wood screws
(30mmX2)
Fisher plugs
(X2)
Metal fittings
(X2)
WARNING FOR INSTALLATION
• Do not attempt install the unit by yourself. In-
correct work will cause electric shock, fire etc.
Consult your dealer or other qualified service
personnel for the installation of the unit.