Sharp FO-2600, Руководство по эксплуатации

Страница: 28 / 105

Storing numbers
Comments:
••
To enter letters for names or correct a mistake, see "Entering letters for names" in this
chapter.
••
You may need to add a pause between certain digits to allow time for connection. For
example, if you are on a PBX telephone system that requires an access number to be
dialled (such as "9") to access an outside line, you may need to enter a pause between the
access number and the number of the receiving fax machine.
••
Pauses are entered by pressing the REDIAL key, and several can be entered in a row if
necessary. The first pause entered gives a time delay of about 4 seconds, and subsequent
pauses give delays of 0.9 seconds each. The total duration of pauses entered for any one
fax or voice number cannot exceed 11 seconds.
••
Rapid key 01 has been set at the factory for use as the Mercury key. If you are not using the
Mercury Service and want to use Rapid Key 01 for Rapid Key dialling, clear Rapid key 01 as
described in "Clearing numbers" which follows in this section, and reset Option Setting 23 as
described in Chapter 6.
••
To confirm that Automatic Dialling numbers have been stored correctly, print out the
Telephone List. The procedure for doing this is described in Chapter 7, "Printing out Reports
and Lists".
Step Press these keys: Comments
1 ENTRY MODE will appear in the display.
2 FAX/TEL # MODE will appear in the display.
3 Select SET.
4
(Example)
To store a Rapid Key number, press a Rapid
Key.
To store a Speed Dial number, press two
numeric keys ("01" to "30").
5
(Example)
Enter the fax number (max. of 20 digits including
pauses) using the numeric keys.
6
If you are storing a Speed Dial number, go to
Step 9 after pressing START.
7
(Example)
Enter a full voice number (max. of 20 digits).
If you don’t want to enter a voice number, skip
this step.
8
S T A R T
FUNCTION
S T A R T
5 5 5 1
4
3
2
3
5
5 5
5 5
3
7
01
1
STORING NUMBERS FOR AUTOMATIC DIALLING
2-8 INITIAL SETTINGS