Sharp DW-209EX, Руководство по эксплуатации

Страница: 14 / 24

14
Press Power ON/OFF button.
●
The operation indicator will stop blinking when the Power ON/OFF button is pressed, and the ON TIMER
operation will be enabled or set. “ON” on the liquid-crystal indicator shifts from blinking into lighting.
●
The TIMER indicator figure will decrease sequentially by “1” following each 1 hour lapse after the
TIMER was set.
(Example) shifts to 8 hours after 9 hours.
FAST
STANDARD
GENTLE
AUTO DRY
ROOM DRY
CONTINUOUS
CLEAN AIR
DRY
FAN SPEED
DEHUMID
SETTINGS
DRY CLOTHES
SETTINGS
ON / OFF HIGH LOW
2
Pip
Lighting
→
Blinking
3
1
2
Pip
Lighting
How to Operate the Timer
How to Operate the Timer
To set on timer
(it can be set only when the unit is shut down.)
(Example of indication)
Standard operation of clothes drying mode
Display of ON TIMER after 5 hours
DRY CLOTHES SETTINGS
button
DEHUMID SETTINGS button
(Example of indication): indicating
state of ON TIMER operation re-
lease
How to cancel ON TIMER operation
Press the power ON/OFF button.
Operation indicator, “ TIMER”, “ON after hours” on the liquid-crystal
part, and “ mark” on operation mode indicator are all turned off. Then
ON TIMER operation is released.
3
If you set ON TIMER operation as “after 5 hours,”
The operation starts after 5 hours.
●
Dispose of water in the tank, since the ON TIMER operation cannot be set when the
Full tank lamp or Full tank indicator is on.
●
It is possible to shift from “DEHUMID SETTINGS” or “DRY CLOTHES” operation
mode after the ON TIMER operation is set. Change it by pressing either of the button.
●
You cannot change the starting time of operation after the ON TIMER operation has
been set. To reset, you need to cancel ON TIMER operation.
Example
Attention
2
Press DEHUMID SETTINGS button or DRY CLOTHES SETTINGS button.
●
Press DEHUMID SETTINGS button when you select DEHUMID operation mode other than “AUTO DRY”.
(The AUTO DRY is indicated as “ mark” on the operation mode.)
●
In case of DEHUMID operation mode, it is possible to operate by “Fan speed/LOW, ON/OFF” or “Fan
speed LOW, ON/ OFF”. Select and press either of them.
Press DRY CLOTHES SETTINGS button when you select a DRY CLOTHES mode other than
“STANDARD”.
(STANDARD is indicated as “ mark” on the operation mode.)
1
Timer setting
button
Operation indicator
Press timer setting button.
You will hear beeping sounds for about one minute after
pressing the key for about 5 seconds.
●
When you note that the “ON” on the liquid crystal indicator starts to blink this indicates that the timer has
been set “ON” after 1 hour.
Select set-time of TIMER since the indication shifts at an hour intervals by pressing Timer setting button
as follows:
●
The indication will continue to shift automatically by pressing the Timer setting button.
No indication
(set release)
( )