E-18
ENGLISH
DK-UH2
DK-UH2(BK)
References
Enhancing your system
The audio cable is not included. Purchase a seperate audio cable as
shown below.
Listening to the audio/video sounds from
portable audio player, computer, etc.
Notes:
When AUX cable is plugged in, the unit will enter the AUX
function automatically.
To prevent noise interference, place the unit away from the
television.
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Remote control
USB
1
Use an audio cable to connect the portable audio player,
computer, etc. to the AUX IN socket.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the FUNCTION button to select AUX.
4
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
AUX IN
DC IN 6V
Computer
Portable audio
player
To the line output socket
N
I
X
U
A
Audio cable
(not supplied)
Symptom
Possible cause
The clock is not set to the
correct time.
Is the Summer Time set to the correct
setting? (Refer to page 9)
Did a power failure occur? Reset the
clock. (Refer to page 9)
When a button is
pressed, the unit does
not respond.
Set the unit to the power stand-by
mode and then turn it back on.
No sound is heard.
Is the volume level set to “0”?
Symptom
Possible cause
The remote control does
not operate.
Is the AC power lead of the unit
plugged in?
Is the battery polarity correct?
Is the battery dead?
Is the distance or angle incorrect?
Is there a strong light shining on the
remote sensor?
Symptom
Possible cause
Device cannot be
detected.
Is there any MP3/WMA file available?
Is the device properly connected?
Is it MTP device?
Does the device contain AAC files
only?
Playback does not start.
Is it a copyright protected WMA file?
Is it a false MP3 file?
Wrong time display.
Wrong file name
display.
Is Variable Bitrate file being played
back?
Is the File Name written in Chinese or
Japanese characters?
Unit always powers on at
AUX function.
Is the AUX cable is plugged in?
