4
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity,
(do not remove the waveguide cover),
and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned door,
damaged door seals around the door or dents inside the oven cavity or on the door. If there is any damage,
please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED BY SHARP
and repaired, if necessary.
2. Accessories
provided
1)Turntable
2) Roller stay
3) Operation manual and Cook book
3. Place the roller stay in the coupling on the oven fl oor, then place the turntable on to the roller stay, ensuring it is
located fi rmly. Refer to OVEN DIAGRAM below. NEVER operate the oven without the roller stay and turntable.
4. The oven should not be installed in any area where excessive heat and steam are generated, for example, next
to a conventional oven unit. The oven should be installed so as not to block ventilation openings. When mounting
on bench top : Allow at least 15cm on the top, 10cm on both sides and 5cm at the rear of the oven for adequate
air circulation.
When building the oven into a cabinet or wall, Sharp built-in kit model numbers RK-J32S are available which enable
the microwave oven to be integrated within a kitchen, the kits are available from your retailer. Read carefully the
installation instructions for the built-in kits before installation. These built-in kits have been tested according to
Australian Standards. Sharp does not recommend the use of any other built-in kits.
If the oven is to be positioned near a conventional oven, ensure that adequate space is allowed, and a suitable
heat shield is incorporated between the two to prevent damage to the oven and the built-in kit caused by heat.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an
emergency.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or personal injury
for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
6. This appliance must be earthed.
7. Operate the oven from a general purpose domestic outlet.
If a generator is used, do not operate the oven with non-sinusoidal outputs.
OVEN DIAGRAM
q
u
o
a
y
e
t
r
j h
r
w
i
d
s
f
g
1. Door open button
2. Oven lamp
3. Door hinges
4. Door safety latches
5. See through door
6. Door seals and sealing surfaces
7. Coupling
8. Waveguide cover (Do not remove)
9. Touch control panel (See page 5)
10. Liquid crystal display
11. Ventilation openings
12. Power supply cord
13. Turntable
14. Roller stay
15. Rating label
16. Menu label
R-331Y(S) OM_P1-P23.indd 4
R-331Y(S) OM_P1-P23.indd 4
3/9/12 2:58:02 PM
3/9/12 2:58:02 PM
Содержание Carousel R-331Y
Страница 1: ...MICROWAVE OVEN A N D MODELS R 331Y S J OPERATION MANUAL COOKBOOK ...
Страница 2: ...1 ...