E – 29
Check the following before calling service:
1. Does the display light when the door is opened and closed?
Yes
_______
No
_______
2. When the door is opened, is the oven lamp switched on?
Yes
_______
No
_______
3. Place one cup of water (approx. 250 ml) in a glass measure in the oven and close the door securely.
Oven lamp should go off if door is closed properly.
Programme the oven for one minute on Microwave 100%. At this moment:
A. Does the oven lamp light?
Yes
_______
No
_______
B. Does the cooling fan work?
Yes
_______
No
_______
(Put your hand over the ventilation openings.)
C. Does the Microwave icon
appear in the display?
Yes
_______
No
_______
D. After one minute, did an audible signal sound?
Yes
_______
No
_______
E. Is the water inside the oven hot?
Yes
_______
No
_______
4. Remove water from the oven and programme the oven for 5 minutes on Convection, Oven 250°C.
A. Does the Convection icon
appear in the display?
Yes
_______
No
_______
B. After the oven stops, is inside of the oven hot?
Yes
_______
No
_______
5. Fill the water tank with water and replace.
Operate the oven for 3 minutes on Manual Steam High.
A. After the oven stops, is the inside of the oven
fi
lled with steam?
Yes
_______
No
_______
If “NO” is the answer to any of the above questions, please check your wall socket and the fuse in your meter
box. If both the wall socket and the fuse are functioning properly, CONTACT YOUR NEAREST SERVICE CEN-
TRE APPROVED BY SHARP.
IMPORTANT: If the display shows nothing even if the power supply plug is properly connected, the Energy Save
Mode may be in operation. Open and close the oven door to operate the oven. See "Getting Started" on page
E-9.
NOTES:
1. If time in the display is counting down very rapidly, check Demonstration Mode. (Please see page E-23 for detail.)
2. If the oven is set for more than about 8 minutes on Microwave 100% power level, output power will be re-
duced to avoid overheating. Finally the output power will be 70% after around 9 minutes.
AC Line Voltage
: Refer to the rating label.
AC Power Required
:
Microwave
1.38 kW
Convection
1.55 kW
Output Power
:
Microwave
800 W
*
(IEC test procedure)
Convection
1.45 kW
Microwave Frequency
: 2450 MHz (Class B/Group 2)
**
Outside Dimensions
: 553 mm(W) x 438 mm(H) x 483 mm(D)
***
Cavity Dimensions
: 359 mm(W) x 256 mm(H) x 339 mm(D)
Oven Capacity
: 31 litre
****
Weight
: Approx. 24 kg
*
This measurement is based on the International Electrotechnical Commission’s standardised method for
measuring output power.
**
This is the classi
fi
cation of ISM (Industrial, Scienti
fi
c and Medical) equipment described in the International
Standard CISPR11.
***
The depth does not include the door opening handle.
****
Internal capacity is calculated by measuring maximum width, depth and height. Actual capacity for holding
food is less.
SERVICE CALL CHECK
SPECIFICATIONS
AX1600 En,P21-29 29
AX1600 En,P21-29 29
15/08/06 16:52
15/08/06 16:52