7
Replacing AR-P15 components
Replacing or adding a DIMM
Each DIMM (dual in-line memory module) is held in place by a lever at each end of its
socket on the AR-P15.
The standard configuration for the AR-P15 is one 128MB DIMM installed in socket
J49. To upgrade to 256MB, install an additional 128MB DIMM in socket J48.
Approved DIMMs are available from your authorized service support center.
T
O
REPLACE
OR
ADD
A
DIMM
1.
To release a DIMM, push outward on the lever on each side of the DIMM (see Figure D).
F
IGURE
D
Releasing a DIMM
2.
Pull the DIMM straight out of the socket to avoid damaging it or the socket, and set the
DIMM aside.
3.
To install a DIMM, insert it straight into the socket. Push the DIMM into the socket until
the levers snap into place.
The DIMM fits the socket only one way. The two notches on the bottom of the DIMM
should line up with the notches in the socket.
Make sure the levers close securely around the ends of the DIMM. Avoid flexing the
board while you firmly seat the DIMM in its socket.
4.
Reassemble the unit and verify functionality (see page 8).
To verify memory capacity, print a Setting List to check the amount of memory recorded.
Lever
Socket notches
DIMM
