Sharp AR-160, Руководство по эксплуатации

Страница: 29 / 82

27
S
T
A
T
U
S
IN
D
IC
A
T
O
R
S
1
Open the bypass tray. Lift slightly on the side cover and
slide the cover out until it stops.
2
Push gently on both sides of the front cover to open the
cover.
3
Lift the TD cartridge lock release lever and pull the
cartridge out until the green strap handle can be grasped
by the right hand. Lift the cartridge by the handle while
supporting it with the left hand at the green label position
to remove it.
●
For disposal of the old TD cartridge, contact your dealer.
4
Remove the new TD cartridge from the bag. Hold the
cartridge on both sides and shake it horizontally four or
five times.
TD CARTRIDGE REPLACEMENT
If the machine detects an insufficient amount of toner being added,
copying will stop and the machine will add toner. During this time, the
START key indicator will blink. When sufficient toner has been added, the
indicator will go out indicating that copying can be resumed. However, if
toner addition continues for a maximum of two minutes, the TD cartridge
replacement required (
) indicator will light up in addition to the START
key being lighted steadily. This indicates that the toner supply is low and
a new cartridge will be needed soon. If copying is continued, the copies
will gradually become lighter until the copier stops and the TD cartridge
replacement required indicator begins to blink, indicating that the cartridge
must be replaced. Replace the TD cartridge by following the procedure
below.
For best copying results, be sure to use only
SHARP products.
The package of SHARP toner has the Genuine
Supplies label.
TD cartridge replacement
TD cartridge lock
release lever
4 or 5 times
GENUINE SUPPLIES