Sharp AQUOS LC-60EQ30U, Руководство по обслуживанию

Страница: 32 / 74

LC-60/70EQ30U
5 – 9
9. Key writing
9.1. MAC address writing (MAIN PWB: QPWBXG577WJ**)
1. Write the MAC address data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
9.2. Netflix, PlayReady key writing (MAIN PWB: QPWBXG577WJ**)
1. Write the NETFLIX,PlayReady key data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
9.3. WideVine key writing (MAIN PWB: QPWBXG577WJ**)
1. Write the WideVine key data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
9.4. Update Logic Serial No. writing (MAIN PWB: QPWBXG577WJ**)
1. Write the Serial No. data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
9.5. HDCP2.2 key writing (MAIN PWB: QPWBXG577WJ**)
1. Write the HDCP2.2 key data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
9.6. HDCP1.4 key writing (MAIN PWB: QPWBXG577WJ**)
1. Write the HDCP1.4 key data on IC3101 mounted on the main PWB.
2. Carry out thorough data management to avoid redundant writing of data.
If the IC where data is written is damaged, replace the PWB since only the IC cannot be changed.
10. Factory setting
After completing the factory setting, pull out the AC cord to complete the setting.
CAUTION: Do not turn on the power after completing the factory setting. If the power is turned on, configure the factory setting again.
11. Software version
1. Main microprocessor
BUFQ_C_xxx.img
2. T-CON ROM
APRICOT_****************.ROM
3. FRC ROM
SHARP_72322_LVDS_(v********_******)_SPI.bin
Adjustment point Adjustment conditions Adjustment procedure
1 Factory setting Complete the setting by
pulling out the AC cord. • Point the cursor to [Factory Init (2/11)] set to, and press the [ENTER] key.
• Completed when Green screen is displayed.
• Turn off the AC power.
Make sure that US indication is displayed on the Factory Init item.
The following items are initialized when configuring the factory setting.
1) User set value
2) Channel data (broadcasting frequency, etc.)
3) Operating time
4) Password setting value
5) V-CHIP block setting value