Sharp AQUOS CRYSTAL 2, Руководство пользователя

Страница: 179 / 190

177
Safety Precautions
AQUOS CRYSTAL 2
Handset & Hardware Care
Handset & Hardware Care
・Use handset within 5
o
C - 35
o
C and 35% - 90% humidity.
・Avoid extreme temperature or direct sunlight.
・Handset/Internal Battery may become warm during operation
or while charging. This is normal.
・Warranty does not cover malfunctions resulting from
misuse.
・Clean handset with a soft dry cloth. Alcohol/solvent use
may fade color/print.
・Avoid scratching Display.
・Avoid heavy objects or excessive pressure. May cause
malfunction or injury.
・Do not sit on handset in back pants pocket.
・Do not place heavy objects on handset inside handbags,
packs, etc.
・Handset back cover is not removable. Do not try to remove
it; may cause damage or malfunction, or affect water
resistance.
・Connect only specified products to Port. Other devices may
malfunction or cause damage.
・Do not power off while using SD Card; may result in data
loss or malfunction.
・When walking outside, moderate handset volume to avoid
accidents.
・When holding handset, do not block Mic/Recorder Mic,
Speaker, Mic, or Mic (Recorder Mic).
・Do not cover Light Sensor or place a sticker/label over it;
may hinder ambient light detection, resulting in malfunction
of Light Sensor.
USIM/SD Card Insertion/Removal
Open Card Slot Cover
Insert/remove USIM/SD Card
・SD Card Slot is located above USIM Card Slot. Insert each
card into correct opening in correct orientation.
・USIM Card Insertion/Removal
・Insert/remove USIM Tray by pulling out USIM Tray. Always
power off handset beforehand.
・When pulling out USIM Tray, gently pull it out horizontally
from the edge. Do not pull USIM Tray forcefully or at an
angle; damage may result.
・When inserting USIM Tray into handset, check orientation,
then gently insert it all the way horizontally.
・When inserting empty USIM Tray, do not insert it at an
angle; damage may result. Check orientation of USIM Tray,
then gently insert it all the way horizontally.
・SD Card Insertion/Removal
・When inserting SD Card, gently insert it all the way
horizontally with terminals facing up.
・When removing SD Card, unmount SD Card beforehand.
・When removing SD Card, lightly push it in and release
finger (SD Card pops out slightly); gently pull it out
horizontally.
Close Card Slot Cover by pressing then
・Press ○ areas firmly so that there is no gap between
handset and Card Slot Cover. Debris trapped between gasket
and Card Slot may allow ingress of liquid.