When recording important selections, be sure to make a
Metal and
tapes should not be used for recording
preliminary test to ensure that the desired material is
or dubbing.
being property recorded.
To erase a recorded tape, press the TAPE (1
2) button
The VOLUME, X-BASS,
SURROUND a n d
to select TAPE 2, press the REC PAUSE
II)
button,
controls may be adjusted with no effect on
the recorded signal. (Variable Sound Monitor)
and finally press the
button.
(Check to make sure that TAPE 1 is not being used.)
TUNER TAPE
-2)
PAUSE
n
CD
POWER
TAPE 2)
TUNER (BAND)
Recording from the built-in radio
n
Dubbing from tape to tape
n
Recording from the built-in CD player
(CD Synchronised Recording System)
1
l
Set the ON/STAND-BY switch to ON,
Press the CD button and load the desired disc.
Use the APMS function to store the tracks you want to record
in memory. (See page 10.)
Load a cassette into the TAPE 2 cassette compartment.
Press the REC PAUSE
II) button.
“CD SYNC” will flash.
Press the
button,
will flash.
CD playback will start approximately 2 seconds after the tape
starts.
To stop recording:
Press the
n
button.
The CD and tape will stop.
Note:
When the end of the tape is reached whilst the unit is rec-
ording, the CD player will display the track number which was
being played at that time, and stop automatically.
After you turn over the tape and press the REC PAUSE
II) button and then button, recording will restart from
the beginning of the track that was interrupted whilst recording
on the first side of the tape.
1 Tune in to the desired station. (See pages 1
Load a cassette into the TAPE 2 cassette compart-
ment.
Press the REC PAUSE
button.
Press the
button.
l
will flash.
Note:
If a whistling noise is heard whilst recording from an
AM station, move the AM loop aerial to a position
where noise is no longer heard from the unit.
To
stop recording:
Press the button on the tape.
1
l
Set the ON/STAND-BY switch to ON.
Load a prerecorded cassette into the TAPE 1 cassette com-
partment. Insert a blank tape into the TAPE 2 cassette com-
.
It is recommended that the recording tape be the same length
as the master tape.
Press the TAPE (1
2) button to select TAPE 1.
Press the REC PAUSE
button.
Press the c
button,
Dubbing from TAPE 1 to TAPE 2 will begin.
To stop
Press the
l
TAPE
dubbing:
button on the tape.
1 and TAPE 2 will simultaneously stop.
