Sharp 8M-B120, Руководство по установке

Страница: 5 / 52

5 5
Copyright © All rights reserved, SHARP CORPORATION
Confidential
Confirmation of before-installation
It is possible to check the conditions of the monitor such as color, brightness, cracking, bright or black dot, leak of light ,by doing the
following steps.(This procedure does not confirm all the functions of this unit.)
Before installation, check if the monitor operates normally and there is anything wrong for the appearance.
If you find any failure after installation, it takes additional time to dismount.
Please check the following items before the installation is performed.
You can connect an AC cable and use the remote control with the monitor standing in the lower box.
Remove the upper box , then lower the protection cover.
After removing the accessory box on the center of rear side monitor, you
can connect AC cable by putting your hand between the protection cover and the
display.
Power connection
Point the remote control at the light receiving part of the center of the
unit and perform the following steps:
You can check the panel condition such as color, brightness, cracking,
bright /black dot, leak of light.
1.Press”MENU” and select “setup” using [↑][↓][←][→] buttons and
confirm with enter.
2.Press [
↑][↓][←][→] to select (Information)-Identification and
confirm with enter.
3.Select “Test pattern”, then the panel status will be displayed.
1.2 Precautions for use