Sharp 8M-B120, Руководство по установке

Страница: 18 / 52

18 18
Copyright © All rights reserved, SHARP CORPORATION
Confidential
2.9 Precautions for space between monitors(Multi-display etc.)
About thermal influence
-In particular, when monitors are installed one above the other, the temperature
raise of topside monitor cause of the exhaust heat from downside monitor.
Regarding the countermeasure against temperature, please keep the clearance
in P.9.
In fact, when installing multi-display, it is hard to keep the clearance in P.9.
Therefore, please keep the temperature requirements to do the
countermeasures as below.
1) Reduce the surrounding temperature(using an air-conditioner)
2)Get down the brightness(when a brightness gets down, a power consumption
and heat gets down)
3)Keep much clearance between the monitors
4)Flow the air forcibly between monitors
It is effective to use the spot cooler or fan in the back(when the monitors are
hit by the wind, they are easily attached the dust).
About expansion
The cabinet and frame of the LCD monitor is expanded due to heat.
It is necessary to secure enough space when aligning multiple monitors.
If the space between monitors is small, the weight is loaded to LCD panel by
heat expansion.
It is necessary to have the gap when installing large monitor. (It is about 5 mm
usually.)
Hiding the gap between the bezels
Black tape
Please be careful not to block it as
much as possible so as to pass
through.
If the gap between monitors spoils appearance (e. g. back of the monitor can
been seen through), please hide it by affixing black tape at the rear.
Note: DO NOT seal the “exhalation fan and intake-nozzle” by black tape.
Please attach the tape in front of connecting cables.
It is necessary to check the tape periodically to make sure that the tape isn’t
detached from the monitor as time goes by.
monitor