420 774 335 397 www.sharks-shop.cz Stránka 29
Installation of welding wire position
Install the wire position on the bracket. Ensure that the spool is installed correctly. To change the
position, press the lock.
NOTICE
The wire coil weight for this model is 5 kg. If this weight is exceeded, the
wire shift will be difficult and the unit may be damaged.
Setting the wire feed roller (feed rollers)
Two grooves of the appropriate dimensions are placed on the welding
wire feeder. The groove size must match the size of the welding wire. To
adjust the size of the wire feed roller, proceed as follows: Unscrew the
welding wire cylinder pressure control knob (1). Press the pressure roller,
then rotate the welding wire cylinder retaining knob (2) and remove the
roller.
Insert welding wire
Prior to installing the welding wire, pull out the welding wire knob (1)
and push the welding wire cylinder to create a gap. Insert
the welding wire into the hole, push the wire into the
groove of the roller and press the knob (10) to adjust the
clamp of the roller for fastening.
ATTENTION:
1. The welding wire is sufficiently elastic and can be
spontaneously unwound when being pulled out of the
bobbin.
2. To properly position the welding wire in the
wire feed slot, the wire should be guided
beneath the coil rather than above it.
