sharkclean .com
sharkclean .com
MAINTENANCE
CLEANING AND REPLACING THE FILTER
Remove and empty the dust bin. Clean any hair or
debris off the
Anti-Tangle Comb
on the back of
the dust bin.
Pull filter out of the dust bin by the tabs.
Lightly tap the filter to remove debris every time
you empty the dust bin. For a deeper clean, rinse
the filter with water once a month. Allow the filter
to air-dry for up to 24 hours before reinstalling. Do
not use soap or scrub the filter. This will damage
the material.
Reinsert the filter into the dust bin, then slide the
dust bin back into the robot until it clicks into
place.
For optimal suction power, after each use, clean and reinsert the filter inside the robot's dust bin.
See sharkaccessories.com for replacement filters.
SELF-CLEANING BRUSHROLL
MAINTAINING THE RESERVOIR AND MOPPING PAD
MAINTENANCE
The
Self-Cleaning Brushroll
actively removes hair wrap while your robot cleans. If some debris remains
wrapped around the brushroll, continue to run the robot to give the brushroll time to clean itself. If some hair
wrap or debris remains after continued cleaning, carefully remove it from the brushroll.
To clean pads, machine wash warm with light
colors. Use mild detergents and do not use bleach
or fabric softeners. Air-dry, or tumble-dry on low
with no dryer sheets.
Empty the reservoir after each use. Rinse the
reservoir and let it air-dry. DO NOT put the reservoir
in the dishwasher.
To access the brushroll, push up on the tabs on the
brushroll door, then lift off the door.
Lift out the brushroll and remove any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll door and press down until both
sides click into place.
NOTE:
Replace brushroll every 6 to 12 months, or when visibly worn. See sharkaccessories.com for replacement parts.
NOTE:
Replace the filter once a year for optimal performance.
NOTE:
Before storing, make sure the reservoir and pad are completely dry. Store the reservoir and pad in a dry place to
prevent damage.
