sharkclean .com
sharkclean .com
DOCK SETUP
INSTALLING THE SIDE BRUSHES
Snap the 2 included
Side Brushes
onto the square
pegs on the bottom of the robot.
If the robot has no charge or it cannot return to the
dock, manually place it on the dock. The indicator
light will turn blue and the robot will beep when it
is correctly placed on the dock.
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If the robot doesn't return to dock, its charge may
have run out, or if it is in wet cleaning mode, the
dock may be blocked by carpet.
CHARGING
IMPORTANT:
The Shark® AI Robot VACMOP™ has a pre-installed rechargeable battery. Charge the battery
completely before first use. It may take up to 6 hours to fully charge.
To charge, place the robot on the dock. The
Power
button on the side of the robot must be in the ON
position (I). The robot will beep when charging begins
and the charging indicator on the dock will turn from
green to blue.
NOTE:
When manually placing the robot on the dock, make sure the
Charging Contacts
on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both white LED lights will flash. When charging is complete,
both white lights will illuminate steadily.
NOTE:
When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
5 ft.
3 ft.
3 ft.
• Select a permanent location with strong Wi-Fi for the
Charging Dock
, because every time you relocate it,
your robot will have to completely re-map your house.
• Place the dock with its back against a wall and attach the landing mat. Select a level surface on bare floor,
in a central area. Do not place dock against baseboards or heating elements.
• Remove any objects that are closer than 3 feet from either side of the dock, or closer than 5 feet from the
front of the dock.
• Plug in the dock. The indicator light will illuminate green when the dock has power.
