9
w w w. shar kclean .eu
TROUBLESHOOTING GUIDE
Customer Service: 0800 862 0453
Vacuum is not picking up dirt. No suction or light suction.
•
Check filters to see if they need cleaning� Follow instructions for rinsing and completely air-drying the filters before re-inserting into the vacuum�
• Dust Cup may be full; empty Dust Cup.
• Check Motorised Floor Nozzle for blockages; clear blockages if required�
• Remove any string, carpet fibers, or hair that may be wrapped around the Brushroll.
Vacuum lifts area rugs.
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
• Turn off the unit to disengage the Brushroll and restart with the POWER slider switch.
• Open the Suction Control Button on the Motorised Floor Nozzle to decrease suction power�
What does the brushroll indicator light mean?
• Solid Green: The brushroll is on and working as it should.
• Solid Red: There is a jam in the brushroll area. Turn your vacuum off and remove the blockage.
• Flashing Red: The motorised floor nozzle is overheating. Turn your vacuum off and wait for it to cool down.
Brushroll does not spin.
• If Brushroll Indicator Light on the Motorised Floor Nozzle turns red, the Brushroll has stopped spinning. Immediately turn off, unplug vacuum and remove
blockage� Replace the power plug into the plug socket and turn the vacuum on�
• If Brushroll Indicator Light on the Motorised Floor Nozzle is green, the blockage has been successfully cleared. If the light is still red, please contact
customer service at 0800 862 0453�
• Check to make sure the Brushroll was replaced correctly if it had been removed.
• Make sure that the 2-speed POWER slider switch on the handle is properly set to the desired floor setting.
• Ensure hood of the Motorised Floor Nozzle is closed completely.
Brushroll access hood will not close.
• Make sure that the Brushroll was reinserted correctly with the pull tab facing up.
Dust Cup will not latch back onto Motorised Floor Nozzle.
• Make sure both the bottom door and filter access are fully closed. Press firmly in the center of the Dust Cup on the Motorised Floor Nozzle until you hear a
click�
Vacuum turns off on its own or the indicator light flashes red.
• This vacuum is equipped with a motor protective thermostat so the vacuum will shut off if it overheats. Should this occur, perform the following steps to
restart the motor thermostat:
1� Turn the unit off�
2� Unplug the vacuum�
3� Empty the Dust Cup and clean filters�
4� Check for blockages in tube, accessories and inlet openings�
5� Allow the unit to cool for a minimum of 45 minutes�
6� Plug in the vacuum�
7� Restart the unit by turning the POWER slider switch on
�
