sharkclean .com
sharkclean .com
MAINTENANCE
SELF-CLEANING BRUSHROLL
MAINTENANCE
To access the brushroll, push up on the tabs on the
brushroll access door, then lift off the door.
Lift out the brushroll and clean off any debris.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down until
both sides click into place.
NOTE:
When cutting away debris, be sure not to cut the brushroll.
NOTE:
Replace brushroll every 6 to 12 months, or when visibly worn. See
sharkaccessories.com
for replacement parts.
NOTE:
The pre-motor foam and felt filters should be replaced every 2.5 years. The post-motor filter should be replaced every 3 years.
NOTE:
Clean the mesh filter inside the dust bin with a small brush once a month.
CLEAN POST-MOTOR FILTER EVERY YEAR
Press the button at the top of the
Filter Door
, then
tilt the door and lift it off. Remove the
Post-Motor
Filter
from the base. To reinstall the post-motor filter,
insert it into the base and replace the filter door.
CLEAN PRE-MOTOR FILTERS ONCE A MONTH
To open the filter housing lid, hold the top right edge
of the base and pull up on the lid. With the lid open,
remove the foam filter by the top handle, then lift out
the felt filter underneath. Tap the filters clean over the
trash, then rinse them with cold water
ONLY
, as soap
may damage them. Allow filters to air-dry completely
before reinstalling them. The filters must be installed
correctly for the base to work properly. Reinsert the felt
filter first, then the foam filter, then close the lid.
For best results, regularly clean and replace the filters in the base.
To clean filters, rinse with cold water
ONLY
to prevent damage from cleaning chemicals. Allow all filters to
air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.
The
Self-Cleaning Brushroll
removes debris over time as it cleans. If some debris remains wrapped around
the brushroll, continue cleaning to allow the brushroll to remove it.
If some debris remains on the brushroll after continued cleaning, follow the steps below to remove it.
CLEANING AND REPLACING THE BASE FILTERS
IMPORTANT:
DO NOT
use soap when cleaning the filters.
Filter
Door
