12
1-800-798-7398
13
sharkclean.com
Fig. 16
Quick
Cord Release
Lower Cord
Storage Clip
STORE YOUR VACUUM SAFELY
1
Convert your vacuum back to upright
vac mode.
2
Rotate the upper quick cord release
to its upright position and coil the
power cord loosely around the two
clips. Clip the plug onto the cord to
secure.
(Fig. 16)
3
Store the dusting brush and the
crevice tool on the mounts on the
accessory holder.
4
Store your vacuum cleaner safely in
a cool, dry area where it will not be
a hazard, will not get damaged, and
will not cause damage to anyone or
anything.
NOTE:
Empty dust cup after
cleaning and prior to storing. (See
Maintenance section for instructions.)
To reduce the risk of electric shock,
unplug the unit before performing
any cleaning, maintenance, or
troubleshooting checks.
Reassemble all parts securely before
operating vacuum.
DO NOT
operate the vacuum without
the filters and dust cup in place.
IMPORTANT:
Make sure all filters are
completely dry before inserting back
into vacuum.
DO NOT
operate the
vacuum with WET filters.
IMPORTANT:
Damages caused
while clearing or attempting to clear
blockages are not covered under your
product’s limited warranty.
Fig. 17
Fig. 18
COMPONENT
MAINTENANCE SCHEDULE
Rinse and air-dry every 3 months under normal use.
Empty each time you vacuum.
Pre-Motor Foam Filter
Dust Cup
Rinse and air-dry every 3 months under normal use.
Pre-Motor Felt Filter
Clean once every 2 years or as needed.
Post-Motor HEPA Filter
1
2
3
4
CLEANING THE PRE-MOTOR
FILTERS
1
Remove the dust cup.
2
Pull the 2 filters out from the top of the
canister.
(Fig. 20)
3
Rinse the filters thoroughly in lukewarm
water until the water runs clear.
DO NOT
put the filter in the washing
machine or dishwasher.
NOTE
: The material in the filter will
discolor over time. This is NORMAL and
will not affect the performance of the filter.
4
Squeeze out excess water and let air-dry
for at least 24 hours before replacing.
DO NOT
use a hair dryer or other heating
methods to dry.
5
Place the felt filter in first, then the
foam filter.
6
Replace the dust cup.
EMPTYING THE DUST CUP
The dust cup needs to be emptied each time
you vacuum and periodically during cleaning,
when the dust cup appears full.
1
Undo the latches on the sides of the dust
cup by lifting them up and outwards to
remove the dust cup from the canister.
(Fig. 17)
2
Hold the dust cup over a trash receptacle
and press the bottom door release button.
(Fig. 18)
Tap gently to empty contents.
Press the door shut again until it clicks.
3
If needed, turn the dust cup upside down
over the trash receptacle and press the
top door release button.
(Fig. 19)
Tap
gently to remove contents.
Use a dry cloth or paper towel to remove
debris stuck to the screen filter inside the
dust cup. Press the door shut again until
it clicks.
4
Replace the dust cup on top of the
canister. Hook the two latches onto the
tabs on the sides of the dust cup and push
down to lock.
Screen
Filter
Fig. 19
Fig. 20
Pre-Motor
Foam Filter
Felt Filter
Post Motor
HEPA Filter
IMPORTANT:
Loss of suction
may occur if pre-motor filters
are not cleaned every 3 months.
Rinse filters only with water and
allow them to air-dry completely.
Also, tap loose dirt off filter
between washes as needed.
Foam filters may appear dirty
after use - this is normal.
STORAGE
MAINTENANCE
