7
8
AUST: 1800 890 840
NZ: 0800 002 999
IMPORTANT:
Always check with the carpet
manufacturer or distributor before using the Shark
®
Activating Pretreater Stain & Odour Remover or the Low
Moisture -No Rinse - Carpet Shampoo. To determine
the colourfastness of any carpet -especially with reds or
blues - take a clean, moist towel and gently rub a small
area in an inconspicuous area. If colour comes off on the
towel, you should discontinue use.
7
Lightly step on the back of the scrubbing head to
release the handle.
WARNING: Never stand on the Sonic Duo
™
.
8
Begin cleaning by pressing the Spray Button to
apply the cleaning solution to the carpet that is to be
cleaned.
(Fig. 12)
Spray the solution continuously
while pushing the unit forward and then pulling it
backward until the area to be cleaned is damp.
NOTE:
The first time that you use the Sonic Duo
™
there may be air in the system causing a delay for
the solution to come out of the spray nozzle. Hold the
spray button down for 5 to 10 seconds until you see
the solution spray out.
9
Using the same back and forth motion, continue
go over the area a few times without spray. Work
your way through the room or area being cleaned
methodically. Repeat as necessary until the entire
carpeted area has been cleaned. No rinsing is
required.
10
If the Reusable Bottle is empty, you can refill it at any
time as long as the Sonic Duo
™
is unplugged from
the outlet.
11
Once finished, step on the tag of the Carpet/Rug
Cleaning Pad and lift the unit to remove the Carpet/
Rug Cleaning Pad from the Sonic Duo
™
(Fig. 13)
.
Let the carpet dry thoroughly and then vacuum.
Using Your Sonic Duo
™
Carpet, Wood & Hard Floor Cleaner
4
Fill the Reusable Bottle with the “Purple” trim and
label with water until the “1:7 Water” fill line and
then with the Low Moisture –No Rinse- Carpet
Cleaner until the “Solution” fill line.
(Fig. 8)
Always fill with water first and then add the
cleaning solution so avoid foaming and ensure
accuracy when measuring.
5
Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit. Push it down to
make sure that it is well inserted. You will hear an
audible “Click” when the Reusable Bottle is inserted
properly.
(Fig. 9)
6
Twist the quick cord release holder to unwrap
the power cord completely.
(Fig 10)
Plug into an
electrical outlet and slide the “ON/OFF” button to
turn the Sonic Duo
™
on. Select the faster Carpet
Mode (II).
(Fig 11)
fig. 9
fig. 6
fig. 8
fig. 7
fig. 10
fig. 11
fig. 12
fig. 13
HIGH TRAFFIC AREA CLEANING
Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
2
Spray the Activating Pretreater Carpet Stain & Odour
Remover to pretreat the area. Spray the area until
saturated and let sit for 5-10 minutes.
Step 2:
3
Attach the Carpet Scrub‘n Stain
™
Pad to the bottom
of the Sonic Duo
™
. This pad has a “Purple” Trim and
tag that says Carpet Scrub ‘n Stain
™
Pad . Attach
the pad as shown in
(Fig. 14)
– the tag should be
positioned toward the back of the Sonic Duo
™
.
4
Remove the Reusable Bottle by holding it and
pulling up.
(Fig. 15)
Remove the cap by turning it
counterclockwise.
5
Fill the Reusable Bottle with the “Purple” Trim and
label with water until the “1:3 Water” fill line and
then with the Low Moisture –No Rinse- Carpet
Cleaner until the “Solution” fill line.
(Fig. 16)
Always fill with water first and then add the
cleaning solution so avoid foaming and ensure
accuracy when measuring.
fig. 14
fig. 16
fig. 15
Cleaning Your Carpets
The Sonic Duo
™
comes with a Reusable Bottle with a
“Purple” cap and label. This bottle is to be used with
the Low Moisture –No Rinse- Carpet Cleaner. The Sonic
Duo
™
also has a second Carpet Mode (II) that should
be used when cleaning carpets. Please note that not
all carpets react to the Sonic Duo the same way. Some
carpets will require more time and cleaning solution than
others.
REGULAR CLEANING
Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in the carpet.
Step 2:
2
Attach the Carpet/Rug Cleaning Pad to the bottom
of the Sonic Duo
™
. This pad has a “Purple” trim
and tag that says Carpet/Rug Cleaning Pad. Attach
the pad as shown in
(Fig. 6)
– the tag should be
positioned toward the back of the Sonic Duo
™
.
3
Remove the Reusable Bottle by holding it and
pulling up
(Fig. 7)
. Remove the cap by turning it
counterclockwise.
