8
9
NOTE:
The first time that you use the
Shark
®
Sonic
Duo
™
Floor Cleaner
there may be air in the system
causing a delay for the solution to come out of the spray
nozzle. Hold the spray button down for 5 to 10 seconds
until you see the solution come out.
6
Lightly step on the back of the scrubbing head to
release the handle and move the agitating
Shark
®
Sonic Duo
™
Floor Cleaner
back and forth over the
area to clean tough, dried on stains faster and easier.
Repeat until the entire floor surface has been cleaned.
No rinsing is required.
WARNING:
Never stand on the
Shark
®
Sonic Duo
™
Floor Cleaner
.
7
Press the Spray Button to apply solution onto the
floor that is to be cleaned.
(Fig. 28)
8
If the Reusable Bottle is empty, you can refill it at
any time as long as the
Shark
®
Sonic Duo
™
Floor
Cleaner
is unplugged from the outlet.
IMPORTANT:
Never leave the
Shark
®
Sonic Duo
™
Floor Cleaner
with a damp/wet cleaning pad on
any floor surface for any amount of time as this may
damage the floor.
9
Once finished, step on the tag of the Hard Floor
Cleaning Pad and lift the unit to remove the pad from the
Shark
®
Sonic Duo
™
Floor Cleaner
.
(Fig. 29)
Using Your Sonic Duo
™
Floor Cleaner - cont.
IMPORTANT:
Make sure the floors are swept or
vacuumed before using the
Shark
®
Sonic Duo
™
Floor Cleaner
.
4
Twist the quick release cord holder to unwrap the
power cord completely.
(Fig. 25)
Plug into an electrical outlet and slide the “On/
Off” button down to turn the
Shark
®
Sonic Duo
™
Floor Cleaner
on. Use “I Low” setting for hard floor
cleaning.
(Fig. 26)
5
Make sure that the Hard Floor Cleaning Pad
is attached to the
Shark
®
Sonic Duo
™
Floor
Cleaner
. This pad has a “Green” trim and the tag
says “Hard Floor Cleaning Pad”. Attach the side
of the Cleaning Pad with the tag to the back of the
Shark
®
Sonic Duo
™
Floor Cleaner
.
(Fig. 27)
fig. 28
fig. 25
fig. 24
IMPORTANT:
When cleaning, do not use the
Shark
®
Sonic
Duo
™
Floor Cleaner
without attaching a Hard Floor Cleaning Pad
and adding the diluted cleaning solution to the Reusable Bottle
first. When polishing, do not use the
Shark
®
Sonic Duo
™
Floor
Cleaner
without attaching a Hard Floor Polishing Pad.
Cleaning Your Hard Floors:
1
To remove the Reusable Bottle, hold it and pull it up
to remove from the unit.
(Fig. 22)
2
Remove the “Green” bottle cap. Add 1 part of the
Sonic Activated Wood & Hard Floor Cleaner solution
to 7 parts water into the Reusable Bottle. Use the
measuring marks on the Reusable Bottle for easy
measuring and filling.
(Fig. 23) Always fill with
cold water first up to the “Water Fill Line”
and then add the cleaning solution up to the
“Solution Fill Line” to avoid foaming and to
ensure accuracy.
3
Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit upside down. Push it
down to make sure that it is well inserted. You will
hear an audible “Click” when the Reusable Bottle is
inserted properly.
(Fig. 24)
IMPORTANT:
Do not use on unsealed wood or
unglazed ceramic floors. Do not use on wood or tile
floors that are highly worn, unfinished or have a wax
or oil finish. Surfaces that have been treated with
wax or some no wax floors may be damaged by the
cleaning and polishing solutions therefore it is always
recommended to test an isolated area of the surface
to be cleaned before proceeding. You should always
check the use and care instructions from the floor
manufacturer.
fig. 22
fig. 23
fig. 26
fig. 29
fig. 27
Frequently Asked Questions
Q.
My
Shark
®
Sonic Duo
™
Floor Cleaner
leaves a
foam on hard floors.
A. The
Shark
®
Sonic Duo
™
Floor Cleaner
Hard
Floor Cleaning Pad is likely too saturated. Replace
it with a clean, dry pad.
Q.
My floors appear cloudy after cleaning.
A.
The
Shark
®
Sonic Duo
™
Floor Cleaner
Hard
Floor Cleaning Pad may be dirty. Change the pad.
OR
A.
The
Shark
®
Sonic Duo
™
Floor Cleaner
Hard
Floor Cleaning Pad was washed with a powder
detergent and may be damaged and require
replacement. Never use powder detergents. Only
use liquid detergent to launder the cleaning pads.
OR
A.
The
Shark
®
Sonic Duo
™
Floor Cleaner
may
have been left in the same spot for too long with a
wet cleaning pad. Never leave the unit with a wet
pad in one spot for too long.
OR
A.
This may be leftover from past cleaners that were
used on the floor surface. Use the
Shark
®
Sonic
Duo
™
Floor Cleaner
a few more times and see if
the leftover cloudiness is removed. If this does not
work, we suggest rinsing the floor with water and
letting it dry. One or more rinses generally removes
the residue. A more stubborn case may require you
to rinse the floor with a mix of one part vinegar to
2 parts water. Then use the
Shark
®
Sonic Duo
™
Floor Cleaner
again with a clean pad.
