4
5
fig. 9
fig. 6
fig. 8
fig. 7
IMPORTANT:
Always check with the carpet
manufacturer or distributer before using the
Shark
®
Activating Pretreater Stain & Odour Remover or
the Low Moisture -No Rinse - Carpet Cleaner.
To determine the colorfastness of any carpet
-especially with reds or blues - take a clean,
moist towel and gently rub a small area in an
inconspicuous area. If color comes off on the towel,
you should discontinue use.
Using Your Sonic Duo
™
Floor Cleaner
fig. 10
fig. 11
Cleaning Your Carpets
The
Shark
®
Sonic Duo
™
Floor Cleaner
comes with a
Reusable Bottle with a “Purple” cap and label. This bottle
is to be used with the Low Moisture –No Rinse- Carpet
Cleaner. The
Shark
®
Sonic Duo
™
Floor Cleaner
also
has a second Carpet Mode (II) that should be used when
cleaning carpets. Please note that not all carpets react to the
Sonic Duo the same way. Some carpets will require more
time and cleaning solution than others.
REGULAR CLEANING
Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in the carpet.
Step 2:
2
Attach the Carpet/Rug Cleaning Pad to the bottom
of the
Shark
®
Sonic Duo
™
Floor Cleaner
. This
pad has a “Purple” trim and tag that says Carpet/
Rug Cleaning Pad. Attach the pad as shown in
(Fig.
6)
– the tag should be positioned toward the back of
the
Shark
®
Sonic Duo
™
Floor Cleaner
.
3
Remove the Reusable Bottle by holding it and
pulling up
(Fig. 7)
. Remove the cap by turning it
counterclockwise.
7
Lightly step on the back of the scrubbing head to
release the handle.
WARNING:
Never stand on the
Shark
®
Sonic Duo
™
Floor Cleaner
.
8
Begin cleaning by pressing the Spray Button to
apply the cleaning solution to the carpet that is to be
cleaned.
(Fig. 12)
Spray the solution continuously
while pushing the unit forward and then pulling it
backward until the area to be cleaned is damp.
NOTE:
The first time that you use the
Shark
®
Sonic
Duo
™
Floor Cleaner
there may be air in the system
causing a delay for the solution to come out of the
spray nozzle. Hold the spray button down for 5 to 10
seconds until you see the solution spray out.
9
Using the same back and forth motion, continue to go
over the area a few times without spray. Work your way
through the room or area being cleaned methodically.
Repeat as necessary until the entire carpeted area has
been cleaned. No rinsing is required.
10
If the Reusable Bottle is empty, you can refill it at
any time as long as the
Shark
®
Sonic Duo
™
Floor
Cleaner
is unplugged from the outlet.
11
Once finished, step on the tag of the Carpet/
Rug Cleaning Pad and lift the unit to remove the
Carpet/Rug Cleaning Pad from the
Shark
®
Sonic
Duo
™
Floor Cleaner
(Fig. 13)
. Let the carpet dry
thoroughly and then vacuum.
4
Fill the Reusable Bottle with the “Purple” trim and
label with water until the “1:7 Water” fill line and
then with the Low Moisture –No Rinse- Carpet
Cleaner until the “Solution” fill line.
(Fig. 8)
Always
fill with water first and then add the cleaning solution
so to avoid foaming and ensure accuracy when
measuring.
5
Screw the bottle cap on tightly and insert the
Reusable Bottle into the unit. Push it down to
make sure that it is well inserted. You will hear an
audible “Click” when the Reusable Bottle is inserted
properly.
(Fig. 9)
6
Twist the quick cord release holder to unwrap
the power cord completely. (Fig 10) Plug into an
electrical outlet and slide the “ON/OFF” button to
turn the
Shark
®
Sonic Duo
™
Floor Cleaner
on.
Select the faster Carpet Mode (II).
(Fig 11)
HIGH TRAFFIC AREA CLEANING
Step 1:
1
Vacuum your carpets and/or area rugs to remove
any loose dirt, dust, or debris that may have
accumulated in your carpet.
2
Spray the Activating Pretreater Carpet Stain & Odour
Remover to pretreat the area. Spray the area until
saturated and let sit for 5-10 minutes.
Step 2:
3
Attach the Carpet Scrub‘n Stain
™
Pad to the bottom
of the
Shark
®
Sonic Duo
™
Floor Cleaner
. This
pad has a “Purple” Trim and tag that says Carpet
Scrub ‘n Stain
™
Pad . Attach the pad as shown in
(Fig. 14)
– the tag should be positioned toward the
back of the
Shark
®
Sonic Duo
™
Floor Cleaner
.
4
Remove the Reusable Bottle by holding it and
pulling up.
(Fig. 15)
Remove the cap by turning it
counterclockwise.
5
Fill the Reusable Bottle with the “Purple” Trim and
label with water until the “1:3 Water” fill line and then
with the Low Moisture –No Rinse- Carpet Cleaner
until the “Solution” fill line.
(Fig. 16)
Always fill with
water first and then add the cleaning solution so to
avoid foaming and ensure accuracy when measuring.
fig. 14
fig. 16
fig. 15
fig. 12
fig. 13
