sharkclean .com
sharkclean .com
CLEANING THE MULTI-SURFACE BRUSHROLL
MAINTENANCE
Push up on the tabs on the brushroll access door,
then lift off the door.
Lift out the brushroll.
Remove the blue cap on the end of the brushroll.
Clean off any hair or debris, then replace cap. Clean
the brushroll periodically and whenever hair appears.
Reinstall the brushroll, inserting the flat end first.
Close the brushroll access door and press down
until it clicks into place.
NOTE:
If the metal cylinder falls out of the brush roll cap, re-insert it in the whole on the inside of the cap. When cutting
away the debris, be sure not to cut the brush roll or any other parts of the robot.
THE BRUSHROLL NEEDS OCCASIONAL MAINTENANCE.
REPLACE BRUSHROLL EVERY 6 to 12 MONTHS, OR WHEN VISIBLY WORN.
See sharkaccessories.com for
replacement parts.
CLEANING SENSORS AND CHARGING PADS
CLEANING SIDE BRUSHES
MAINTENANCE
Carefully unwind and remove any string or hair
wrapped around brushes.
Gently wipe brushes with a damp cloth. Be sure to
let them air-dry completely before reinstalling them.
CLEAN SENSORS AND CHARGING PADS PERIODICALLY AS NEEDED.
With a dry cloth or cleaning brush, gently dust off
the sensors and pads located on the bottom of the robot.
NOTE:
Remove any side brushes that are bent or damaged. To remove a brush, lift it off its peg. See
Installing the Side
Brushes
for instructions on how to attach and remove the brushes.
IMPORTANT:
The robot uses cliff sensors to avoid stairs and other steep drops. Sensors may work less effectively when
they are dirty. For best results, clean sensors regularly.
CLEAN SIDE BRUSHES AS NEEDED. CHECK WEEKLY.
RECOMMENDED REPLACEMENT SCHEDULE:
Replace when visibly worn. See sharkaccessories.com for replacement parts.
