Shannon HRP 220, Руководство пользователя

Страница: 20 / 50

User’s Guide
HRP 220 - 19 -
HS
Adjustment 8
8.3 UPPER HEATING ELEMENT AND
PRESSURE BAR
1.
Disconnect the compressed air.
The top frame will then slowly lower while air escapes.
The power is automatically switched off.
2.
Loosen the socket head screws on the support bar clamps
one turn. (Use socket screw
no. 6 ).
3.
Take hold of the heating element at the sides, left and
right, and slide it into the desired position. Move the
support bar parallel to the front of the top frame, so that
you position the top filament above the bottom one.
4.
Tighten the support bar clamps again.
5.
Switch on the machine again as in Section 7 .
The upper heating elements and pressure bars may fall out of
the top frame if they are loose or not properly attached.
8.4 LOWER FILAMENT HEIGHT
1.
Adjust the height of the filament using the knurled nut.
These can be reached from the sides. Make sure that the
filament height is the same on both sides.
2.
Start up the machine again as in Section 7 .
Knurled nut
1
2
3
Support bar clamp