Shaktiman Fertilizer Broadcaster, Руководство оператора

Страница: 19 / 36

"
Place the tractor and the implement on a flat surface
Attach the 3 point linkage of the tractor (see the section attaching and detaching the implement)
Find the length between the grove of PTO output on the tractor, and the PTO input on the
implement when the implement and tractor is in horizontal position.
Raise the implement fully and measure from end-
to-end between the two groves. It is used to
determine the shortest distance.
Lower the lift to about half and re-measure the
distance, then drop the lift to the bottom and re-
measure again.
Let the shortest distance be A and the longest
distance be B. (Fig. 7.4)
Put the both halves of the propeller shaft on a flat
surface parallel to each other (Fig. 7.6) in such a
way that the distance between the two push pin (1)
of the yoke should be equal to the shortest
distance A.
Measure the minimum clearance, this distance should be minimum 4 cm (Fig. 7.6), if this
distance is more than 4 cm then no need to cut the shaft. If the clearance is less than 4 cm then
cut the pipe of propeller shaft along with cover both side such that the minimum clearance of 4
cm is maintained.
Again, put the both halves of the propeller shaft on a flat surface parallel to each other (Fig. 7.5)
in such a way that the distance between the push pin (1) of the yoke should be equal to the
maximum distance B. If the minimum overlap is 15 cm then no need to resize the propeller shaft
and it is ready to be fit the tractor with the implement.
Danger: failure to make these adjustments will damage the unit and causes personal injury.
Note : Clean the filings from the metal and dress the edges of the cuts with a file when
done.
#