Shakmat Harlequin's Context, Руководство по эксплуатации

Страница: 19 / 21

www.shakmat.com
•
18/19
12. First startup routine
Make sure all the potentiometers are fully counterclockwise when turning
on your Harlequin’s Context for the first time. Plug in the power cable and
make sure the red side of the ribbon matches the -12V on the PCB. Now let's
plug the module into your system and test it. The module identifies the first time
it turns on and automatically starts the calibration, test and factory reset
routines.
Turn on your rack. The Harlequin’s display shows a “C” for calibration.
• Patch the channel A output into the CV input and press the Scene 1 button
• Patch the channel B output into the CV input and press the Scene 2 button
• Patch the channel C output into the CV input and press the Scene 3 button
• Patch the channel D output into the CV input and press the Scene 4 button
The calibration is now done and the Harlequin automatically switches to the
test routine :
• Each output produces a ramp (saw up LFO)
• CV input positive voltage values are displayed on the 7 segment display
• When an active gate is received in the gate input, the screen turns off
Therefore, patch each channel’s output into the CV input (the 7 segment
display will give values from 0 to F). Patch one of the outputs into the gate
input (the 7 segment display should slowly blink).
To test the white and amber LEDs, press each of the eight buttons of your
Harlequin’s Context. When pressed, each button lights an individual LED up.
The green LEDs show the potentiometer value by their intensity. Turn all the
potentiometers fully clockwise until all the green LEDs are fully on. You will exit
the test routine when all the potentiometers are fully clockwise.
Now hold the first Scene button until the display shows the letter “F”.
Press the Store button to start the Factory Reset routine. This operation will
clear all the non volatile memory, slot by slot, and the display will show the slot
currently being cleared (from 1 to G).
Once the Factory Reset routine is done, the module will start normally.