Shakmat Harlequin's Context, Руководство по эксплуатации

Страница: 13 / 21

www.shakmat.com
•
12/19
7. PCB stacking
It’s now time to join and solder the two PCBs together. Be very careful during
this step. If you solder every pin and the PCBs arn’t well aligned, you will likely
not be able to correct it and will encounter all sorts of problems on your way to
the end of this build.
The first step is to assemble the two PCBs as shown above, and only solder
the first pin of the small vertical header. It is vey important that you firmly hold
the two PCBs against each other while soldering this point. There must be no
gap between the PCBs and the header’s black plastic part between them.
Once you’ve soldered the first point, you can move on to the second header
as shown below. Repeat the same procedure as for the first point for all of the
four points listed. Once they are all perfect, without any gap between the
PCBs and headers, you can solder every remaining point.
02
01