ShadeLab SVET, Инструкция по сборке

Страница: 18 / 24

18
| | ASSEMBLY
6 - REGULATING THE AWNING
Once the awning has been assembled, to check that all the components are correctly
fitted you must:
»
Make 2-3 test cycles of opening/closing the awning.
»
Regulate any components that prevent the correct and unimpeded opening and closing move-
ment of the awning.
ATTENTION
Ensure that there are no persons, animals or things in the vicinity while opening/clos-
ing the awning.
Regulating the awning:
slacken the side screw (see ref. 26 fig. 27)
of the arm support (Allen wrench 10). To
increase the inclination slacken the socket-
head screw (see ref. 27 fig. 27), (Allen wrench
8). To decrease the inclination tighten the
socket-head screw, raising the terminal bar.
After regulation, check that the terminal bar
is perfectly horizontal.
With the awning almost closed, check that
the arms are parallel.
If they are not parallel, tighten or slacken the
dowel (see ref. 28 fig. 28) in the lever (Allen
wrench 3), accompanying the arm.
fig.27
fig.28
ATTENTION
After regulation, firmly tighten the side screw.
27
26
28