ShadeLab SVET, Инструкция по сборке

Страница: 17 / 24

| ASSEMBLY |
17
Push the arms towards the square bar, cen-
tre the terminal bar with the fabric; once this
has been checked, the terminal bar connector
screws can be tightened (Allen wrench 5).
ATTENTION
Ensure that the terminal bar is firmly fixed
to the arms to prevent their opening without
control.
If the arm holders are not used, proceed as
follows:
Assemble the terminal bar inserting the fabric
in the ogive (see ref. 23 fig. 23) in the terminal
bar. Sliding the terminal bar, check that the
2 plates of the terminal bar connections are
in their proper place and proceed as in figure
22.
fig.22
fig.23
After having checked the tightness of the
terminal bar connecting screws, remove the
bands from the arms and open the awning.
Fix the fabric to the terminal bar. Perform two
awning opening/closing cycles.
fig.26
Fit the caps (see ref. 25 fig. 25) on the arm
supports and on the brackets.
fig.25
Insert the terminal bar caps (see ref. 24 fig.
24).
fig.24
23
24
25