PAGE 9
PAGE 8
CONVERT UNIT FROM VACUUM USE TO BLOWER USE
1. Remove the elbow tube and vacuum bag by turning the bolts
anticlockwise to loosen the elbow tube.
2. Remove the vacuum tubes by turning the tubes clockwise.
3. Close the vacuum inlet cover and make sure it is latched closed.
4. Reinstall the blower tubes (see BLOWER TUBE ASSEMBLY).
1. Pass the shoulder strap over your head and onto your left shoulder.
2. Extend your right arm toward the rear of the vacuum bag.
3. Adjust shoulder strap until the vacuum bag/shoulder strap seam lies
between your thumb and index finger.
4. Make sure air flows freely from the elbow tube into bag. If bag is kinked,
the unit will not operate properly.
Inspect area before start ing unit. Remove all debris and hard objects such
as rocks, glass, wire, etc. that can rico chet, be thrown, or otherwise cause
injury or damage during operation.
This machine produces an electromagnetic field during operation. Under
some circumstances, this field may interfere with active or passive medi-
cal implants. To re duce the risk of serious or fatal injury, we recom mend
persons with medical implants to consult their physician and the medical
implant manufacturer before operating this machine.
SHOULDER STRAP ADJUSTMENT
SAFETY BEFORE USING
1. Stop engine and be sure the impeller blades have stopped turning
be fore opening the vacuum inlet door.
2. Turn the knob anticlockwise untill the knob is loose.
3. Pull up the vacuum inlet cover with your hand. Hold the vacuum inlet
cover open until up per vacuum tube is installed.
4. Align the switch on the inside of the vacuum inlet with the slot on the
upper vauum tube.
5. Push the upper vacuum tube into the vacu um inlet. Turn the tube anti-
clockwise to secure the tube to the blower unit.
6. Align the rib on the lower blower tube with the rib on the upper blower
tube. Slide the lower vacuum tube on to the upper vacuum tube.
7. When vacuum tubes are fitted together assemble the two tubes
together with the supplied screws.
ASSEMBLY: VACUUM TUBE
WWW.SGS-ENGINEERING.COM