PAGE 7
PAGE 6
ASSEMBLY: VACUUM
1. Open the zipper on the vacuum bag and insert the elbow tube.
2. Push the small end of the elbow tube through the small opening in the
bag. Make sure edge of the small opening is flush against the flared area
of the elbow tube, and the rib of the elbow tube is on the bottom.
3. Close the zipper on the bag. Make sure the zipper is closed completely.
4. Remove blower tubes from engine.
5. Insert the elbow tube into the blower outlet. Make sure elbow tube rib is
aligned with the blower outlet clamp bolt (upper).
6. Secure the elbow tube by turning the bolts clockwise.
1. Align the rib on the upper blower tube with the clamp bolt (upper) in the
blower outlet, slide the tube into place. Tube clamp bolts must be loose
enough to allow blower tube to be inserted in blower outlet. Loosen the
bolt by turning anticlockwise (do not remove nuts).
2. Secure the tube by turning the bolts clockwise.
3. Align the rib on the lower blower tube with the rib on the upper blower
tube.
4. Slide the lower blower tube onto the upper blower tube.
5. Secure the tube by turning the bolts clockwise.
6. To remove the tubes, turn the bolt counterclock wise to loosen the
tubes.
ASSEMBLY: BLOWER
WWW.SGS-ENGINEERING.COM