TVC-TRF-10-AAT
28
© SGS electronic 2006-2021
5
Initialization
5.1
turn on sequence
1. connect the battery
2. turn on the transmitter
3. all control sticks and trims must be centered
4. turn on the receiver. The LED lights for approximately 1 second.
5. the speed controls sense center point of the channels and the LED on the
board flashes. If the operation is not successful the LED does not light.
To repeat the operation turn the receiver off and on again
6. if the LED shines the model is ready for operation
This process is repeated at
every
start. The start position of the controls are set
as center . This applies to all channels.
When doing the calibration, the optional channels can be left unconnected.
In this case the module detects the channels to be unused. You can not connect
an optional channel after the calibration finished.
Case one of the not optional channels leaves unconnected, the calibration
will not end and the LED keeps on flashing.
5.2
operation modes
The green LED 3 on the module shows the active operation mode. The LED
flashes like this.
1 flash
normal drive mode
2 flashes
parking mode
3 flashes
model unselected (passive)
4 flashes
destroyed (battle unit)
5 flashes
damaged (battle unit)
6 flashes
invulnerable (battle unit)
