8
Rigging process
Start the rigging process by clearing the working area below, and make sure the work is performed from a stable platform.
1.
Check that the clamp is undamaged and can bear at least 10 times the weight of the fixture. Check that the structure can
bear at least 10 times the weight of all installed fixtures, lamps, cables etc.
2. Bolt the clamp securely to the omega bracket with a M12 ½ bolt (min. grade 8.8) and a lock nut.
3. Align the omega bracket with the two 1/4 turn sockets in the base. Insert the fasteners into the base bracket, and turn both
levers a full1/4-turn clock wise to lock.
4.
Working from a stable platform, hang the fixture on a truss or other structure. Tighten the clamp.
5.
Install a safety wire that can bear at least 10 times the weight of the fixture. The safety wire attachment point is designed to
fit a carabiner.
6.
Verify that there are no combustible materials, cables, or surfaces to be illuminated within 0.3 m (12 in) of the fixture.
7.
Check that there is no risk of the head/yoke colliding with other fixtures or structures.
Holes for omega bracket
Omega bracket
Figure 3: Base with omega bracket
