SG Security Communications Skyroute UT, Руководство по установке

Страница: 5 / 30

4
1.2 Out of the Box
Please verify that the following components are included in your system:
• one Skyroute module
• one PC1-OUT module
• one antenna
• one PC5003C main control cabinet
• one PC580 main control circuit board
• one Installation Manual with programming worksheets
• one hardware pack consisting of:
- four plastic circuit board standoffs
- ten 5600
Ω
(5.6K
Ω
) resistors
- one 2200
Ω
(2.2K
Ω
) resistors
- one 1000
Ω
(1K
Ω
) resistors
- ground connection assembly
- one cabinet door plug
Getting Started
Read this section completely before you begin. Once you have an overall understanding of the installation
process, carefully work through each step.
2.1 Installation Steps
Step 1: Mounting the Unit
Mount the panel in a dry area close to an unswitched AC power source. Before attaching the cabinet to the wall,
be sure to press the four circuit board mounting studs into the cabinet from the back.
NOTE: You must complete all wiring before connecting the battery, or applying AC to the panel.
Step 2: Mounting the Skyroute Transceiver
The Skyroute Transceiver can be mounted in the upper right hand corner of the panel cabinet through
the knock out.The Skyroute Transceiver case attaches to the panel cabinet through the use of clips.
Step 3: Mounting the Antenna
NOTE: The antenna should always be attached to the Skyroute Transceiver for proper operation. The
unit will not function properly if the antenna is not installed.
The antenna attaches to the TNC connector of the Skyroute Transceiver.The antenna should be mounted
as high above ground level as possible while at the same time taking care not to place the antenna
under a Radio frequency shield of any kind. For example do not mount the antenna directly below a
metal roofing over-hang. The Skyroute Transceiver functions best when installed in an unobstructed
“line of sight” to the cellular antenna site.
Step 4: Panel Wiring
Install the 1k
Ω
resistor (brown, black, red) across the Bell+ and Bell- terminals. Connect all the
zone inputs using the 5.6k
Ω
resistors (violet, blue, red). Follow connection diagram on page 20
for different configurations.