SG Models Radial Rocket TD 10cc, Инструкция по сборке

Страница: 23 / 31

Instruction Manual.
23
.
.
2) Using a modeling knife, carefully re-
move the covering at mounting slot of
horizontal stabilizer ( both side of fuse-
lage).
Draw center line
INSTALLING THE HORIZONTAL
STABILIZER.
1) Using a ruler and a pen, locate the cen-
terline of the horizontal stabilizer, at the
trailing edge, and place a mark. Use a tri-
angle and extend this mark, from back to
front, across the top of the stabilizer. Also
extend this mark down the back of the
trailing edge of the stabilizer.
3) Slide the stabilizer into place in the
precut slot in the rear of the fuselage.
The stabilizer should be pushed firmly
against the front of the slot.
INSTALL ELEVATOR CONTROL HORN.
Fiberglass control horn.
Epoxy.
Elevator fiberglass control horn.
Epoxy.
4) With the stabilizer held firmly in place,
use a pen and draw lines onto the stabi-
lizer where it and the fuselage sides meet.
Do this on both the right and left sides
and top and bottom of the stabilizer.
Pen