2
1.
INTRODUCTION
Thank you for choosing Xtremesolar Modules powered by SFCE. All Xtremesolar modules are manufactured
by SFCE for the exclusive distribution to market by Sonepar Australia, Solar + Solutions.
This Installation Manual contains essential information for electrical and mechanical installation that you
must know before handling, installing Xtremesolar Modules. This Manual also contains safety information
you need to be familiar with. All the information described in this Manual is the intellectual property of SFCE
and is based on the technologies and experience that have been acquired and accumulated by SFCE.
This Manual does not constitute a warranty, expressed or implied. SFCE does not assume responsibility and
expressly disclaims liability for loss, damage, or expense arising out of or in any way connected with
installation, operation, use or maintenance of Modules. No responsibility is assumed by SFCE for any
infringement of patents or other rights of third parties that may result from use of Modules. SFCE reserves
the right to make changes to the product, specifications or installation manual without prior notice.
Failure to comply with the requirements listed in this manual will invalidate the Limited Warranty for
Modules as provided SFCE at the same time of sale to the direct customer. Additional recommendations are
provided to enhance safety practices and performance results. Please provide a copy of this manual to the
PV system owner for their reference, and inform them of all relevant aspects of safety, operation, and
maintenance.
2.
CODES AND REGULATIONS
The mechanical and electrical installation of PV systems should be performed in accordance with all
applicable codes, including electrical codes, building codes and electric utility interconnect requirements.
Such requirements may vary for mounting location, such as building rooftop or motor vehicle applications.
Requirements may also vary with system voltage, and for DC or AC application. Contact local authorities for
governing regulations.
3.
GENERAL
Figure 1 Modules components and cross-section of the laminated assembly