Servomex AquaXact 1688, Руководство оператора

Страница: 24 / 38

24
© Servomex Group Limited 2017 AquaXact Issue 1.0
Therefore for long term storage, it is recommended that the sensor be removed from the
storage bottle every 30 days to sustain the moisture level in the sensor. The sensor should
be exposed to ambient conditions for approximately 2 minutes then returned to the storage
bottle. Note that the ambient conditions should be between 15 °C to 25 °C with a relative
humidity between 35% and 90%. This will allow the sensor to absorb enough moisture to
remain properly hydrated.
Sensors left in storage bottles for more than three months without a wet up cycle being
performed need to be exposed to 3 - 5 wet/dry cycles with a dew point high and low
between -70 °C and + 20 °C before being put into service.
Note: The impact of long term storage is just a temporary slowing of the response to dew
point changes and does not impact the overall life span of the sensor.
Do not store replacement tips for more than 12 months before use to
assure the calibration is still valid.
Refit the protective plastic sensor enclosure (section 2) and place the transmitter in its
original packaging before storage. Alternatively, seal it inside a waterproof plastic bag,
sack, or storage box.
Store the equipment in a clean, dry area. Do not subject it to excessively hot, cold, or
humid conditions (section 6).
Disposal 9.2
Dispose of the transmitter safely, and in accordance with all of your local and national
safety and environmental requirements.
Hint: If you send the equipment to Servomex or your local Servomex agent for
disposal, it must be accompanied by a correctly completed decontamination
certificate and a Return Authorization Number (RAN) (section 11.2).