I N T R O D U C T I O N
6
Residential Cleaning Manual
RECOMMENDED PREVENTIVE MAINTENANCE
n
UNPLUG
the vacuum when performing any maintenance.
n
CHECK
the condition of all electrical cords before each use.
UPON RECEIPT
Check unit for any damage, missing or broken parts. Call ProTeam with this information,
along with any questions you may have.
DAILY/AFTER EACH USE
Check Intercept Micro Filter. Empty/remove if full. All ProTeam vacuums must use genuine
Intercept Micro Filters to maintain valid vacuum warranty. Check Micro Cloth Filter. If dirty,
rinse out and air dry before replacing back into vacuum. All filters must be in place to oper-
ate vacuum. This will optimize airflow and prevent the motor from laboring.
PERIODICALLY
Check harness for fit and comfort. Replace lost or damaged pieces.
ELECTRICAL CORD CARE
NEVER
stretch the cord tightly between the vacuum and the outlet. A cord that is stretched or
pulled will not function properly and can damage the cord or plug, and creates a tripping hazard
DO NOT
tie extension cord and power cord together in a knot in an effort to keep the con-
nection together. Doing so will result in damage to both cords and will not be covered
under warranty. Instead, use the provided cord holder.
After vacuuming, unplug the extension cord at both ends and wind it up loosely.
• Wind the cord from the female receptacle to the male plug.
• Lay the cord out, as straight as possible, on the floor before winding.
•
DO NOT
wind the cord up by wrapping it around your hand and elbow, as repeated
winding in this manner will result in twisted cord that is hard to wind and unwind.
Use only a ProTeam replacement extension cord, or one that is properly sized for your applica-
tion. Extension cord jacket type should be SJT or better and rated for outdoor use. Extension
cords in poor condition or too small in wire size can pose fire and shock hazards. To reduce the
risk of these hazards, be sure the cord is in good condition and that liquid does not contact the
connection. Do not use an extension cord with conductors smaller than 16 gauge (AWG) in
size. To reduce power loss, use a 14 gauge extension cord if longer than 100 ft.
PROPER STORAGE
When the vacuum is not in use, the vacuum and extension cord should be stored indoors
and in a dry place.
• The following information is for use by qualified service
personnel only, and provides guidance for troubleshoot-
ing and maintenance under normal working conditions.
• UNPLUG
the vacuum when working on the motor or any
electrical part.
MOTOR BRUSHES
Only a ProTeam-authorized service or warranty center should replace the carbon motor
brushes. Use the following schedule for replacement:
1. After the first 800 hours of operation.
2. Again after the next 400 hours of operation.
3. Again after the next 200 hours of operation.
WARNING
WARNING
Содержание 15700 SVM
Страница 31: ......