Menu Structure Description
This is a more detailed description of each menu item.
1. Setpoints
If user password has been enabled, you will need to enter the password before you
can change any setpoint.
2. Schedule
If user password has been enabled, you will need to enter the password before you
can change the schedule.
You can enter up to 3 scheduled items. Each item determines when the room is
Occupied by specifying a start time and a stop time. You also specify which day
of the week the scheduled item applies (Monday-Sunday, Workdays, Weekends
or All).
If there are conflicting items then the priority goes to day items (Monday-Sunday)
followed by Workday and Weekends and last All. Use this to your advantage by
specifying a default schedule using All and then add a schedule item for days
where the default does not apply (e.g. Weekends, Sunday).
3. System
3.1. Ventilation
Currently you can only turn the blower on or off on this screen. Note that
the blower might not come when turning it on. There can be an alarm
condition preventing it from starting (e.g. blower overload, voltage
monitor fault or firestat).
When selecting Normal Mode at startup, the blower will automatically be
set to On. To not run the blower you will have to go to this menu and turn
blower off. There might be up to a minute delay before blower starts due
to the voltage monitor fault signal not begin cleared.
When selecting Service Mode at startup, the blower will be set to Off.
3.2. Purge
By selecting the Purge menu item you will get to the Purge activation
screen. At this screen you can set the length of time the system will purge
and start/stop purging.
At the bottom of the screen you can see the current status. It can show Off,
PendingPurge or number of minutes remaining of ongoing purge.
OperatorPanel_4.15.14.doc
Page 12
7/12/2012
