DA
L
19
65
Page 16/18
TECHNICAL DATA OF THE CR/41/ CONTROL UNIT
Power supply:
230Vac ±10% 50/60Hz
Motors power supply:
Two 230Vac single-phase motors, 200W+200W
Accessories power supply:
24Vac 500mA
Flashing light power supply:
230Vac, max 50W
Courtesy light power supply:
230Vac, max 100W
Electric lock power supply:
12Vac 15VA
Motors working time adjustment:
from 0 to 120s
Pause time adjustment:
from 4 to 120s
Phasing regulation in opening and closure:
from 0 to 15s
Operating temperature:
-20°C ÷ +70°C
Protection rating:
IP54
Dimensions (H x L x D) and weight:
270x212x118mm, 1,7Kg
EXPANSION OF THE MINITRANSMITTER NUMBER
If the 32 minitransmitters that can be memorised in the built-in receiver are not sufficient, it is possible to increase them
by inserting the SOG/4A receiver (that takes the number of minitransmitters to 40) eventually with the addition of the
SOG/2A expansion (that takes the number of minitransmitters to 834).
After having inserted the SOG/4A receiver, all codes memorised in the built-in receiver must be deleted and all
of the minitransmitters must be re-programmed on the new SOG/4A receiver, see specific instructions. The an-
tenna must be moved from the clamp on the control unit to the clamp found on the SOG/4A.
F1F1
F2
F2
ON
SW1
SW2
3 4 5 6 7 8
SOG/4
POWER
+
-
ON
PED
START STOP FOTO FOTO AP FINE CH FINE AP
DL9
DL8
DL10
1 2
9 10
11121314 1516171819 20
21
22
27
2526
2324
SET
BREAK
WORK
A
B
C
Com
+24
spia
RX
2829
2ND CHANNEL
OUTPUT:
AUXILIARY
CONTROL
ANTENNA
NC
C
NO
Channel 2 output (relay contact)
Max Voltage applicable=
24Vac/dc
Max Current applicable=
1A
ELECTRIC LOCK
LIGHTS
OTHER AUTOMATIONS
OTHER
INSERT THE
SOG/4A
RECEIVER
1ST CHANNEL OUTPUT:
CONTROL UNIT
START CONTROL
PEDESTRIAN CONTROL
ON CR/41 -CLAMPS 1-2-
DISCONNECT THE POWER
SUPPLY BEFORE INTERVENING
ON THE CONNECTIONS
NO
K
IT
/A
9
I
E
