47
STEP 1
Release the throttle lever, and the engine
speed will decrease.
STEP 2
Stop the engine by setting the switch to “0”
position.
WARNING! Unused fuel may still remain in the
fuel tank after operation of the tool. If this is
the case, completely drain fuel into a can.
Do not leave the fuel mixture in the
brushcutter fuel tank for more than 12 hours.
This can cause unstable engine running.
Always use SEQUOIA 2T-Original oil for two-
stroke engines. It is forbidden to use four-
stroke engine oils for preparation of the fuel
mix.
Commissioning data and recommendations on the use of the petrol brushcutter
Running in period for a new engine makes 5-8 fuel tanks. It is not recommended to operate the tool at maximum engine speeds for a long time
or to use a cutter blade during the running-in period. Operate the petrol brushcutter by combining loaded mode of operation and short no-load
periods.
WARNING!
Use cutting line recommended by the manufacturer.
Diameter of the cutting line shall not exceed 3.0 mm
TURNING OFF THE PETROL BRUSHCUTTER
