SEPTENTRIO AsteRx SB ProDirect, Руководство пользователя

Страница: 10 / 35

CHAPTER 3. CONF I GUR I NG THE ASTERX SB PRO D I RECT
3.1.2 Connecting to the web interface via Ethernet
Step 1: Connect the Power and Ethernet cables
Connect the Ethernet cable to the connector labeled ’ ETH ’ on the rear panel of the receiver
as shown in Figure 3-2 and make sure it is connected to a LAN network. Then connect the
power cable to the receiver and make sure the correct input voltage is applied (between 5
and 36 V DC). Note that in case the receiver is powered over Ethernet, connecting a power
cable is not necessary.
Figure 3-2: Rear panel Ethernet socket
Step 2: Open a web browser and connect to the AsteRx SB
ProDirect
By default, the AsteRx SB ProDirect has the hostname ’ http://asterxsb-xxxxxxx ’ , where
xxxxxxx are the 7 digits of the serial number of the receiver board inside the AsteRx SB
ProDirect. This hostname can be used on a local area network to connect to the AsteRx
SB ProDirect if the
I P address assigned by the DHCP server is unknown. The hostname
can be found on a sticker on the bottom of the receiver housing. Figure 3-3 shows a
screenshot of an Ethernet connection to a receiver with serial number 3034022 using
’ http://asterxsb-3034022 ’ .
Figure 3-3: Connecting to the Web I nterface via Ethernet
10