SentrySafe Master Lock Fire-Safe FP082C, Руководство пользователя

Страница: 13 / 48

13
English
Troubleshooting
The Problem: Why it is Happening: The Solution:
The door will not
close and lock. 1. Confirm that there is no
obstruction in the door.
2. Bolted down incorrectly.
1. Remove all items and accessories
from inside the safe. If this resolves
the issue, re-set the accessories and
organize items to properly fit.
2. See pages 11 for proper bolt-down
instructions.
After inputting the
programmable code,
the door does not
open. 1. Battery Power may be low.
2. May be the wrong battery
type. 1. Use override key to open the safe
and replace batteries.
2. Use 9 volt battery to open your safe
and replace the batteries.
Red indicator light
blinks three times
and there are
three beeps. An incorrect code has been
entered. Verify code and re-enter. If the pro-
grammable code you are using does
not work then use the factory code. If
successful re-program your program-
mable code.
Red indicator light
blinks five times and
there are five beeps.
Keypad communication error. Please call our Customer Service center.
Red indicator light
blinks once and there
is one beep. 1. Program button is pressed out
of sequence.
2. 5 seconds has lapsed between
button entries.
Start over.
Red indicator light
is blinking. An incorrect code has been
entered three times and system
has entered delay mode. Wait two minutes and start over.
Yellow indicator light
is on.
1. Battery power is low.
2. Battery may be the wrong
type.
Replace with new CR123 lithium
batteries.