Sentry CA756, Инструкция по эксплуатации

Страница: 8 / 85

15
14
If is pressed without entering a value, the current
number of memories available and remaining steps will be
displayed .
... Specifies COMP mode for arithmetic
calculation or function calculation (program
execution possible).
... For binary, octal or hexadecimal calculations/
conversions (BASE-N mode).
... For standard deviation calculations (SD mode).
... For regression calculations (LR mode).
...Pressed after a numeric value
representing degrees ( 0 ) is input.
...Pressed after a numeric value
representing radians ( r ) is input.
...Pressed after a numeric value
representing grads ( g ) is input.
Alphabet key
Press to input alphabetic characters or special characters.
Pressing displays and allows the input of only
one character. After that, the unit returns to the status it
was in before the key was originally pressed.
Pressing followed by will lock the until in this
mode and allow consecutive input of alphabetic characters
until is pressed agian.
angular measurement is specified as
degrees.
... displayed. If is pressed, unit of
angular measurement is specified as radians.
... displayed. If is pressed, unit of
angular measurement is specified as grads.
... Fix displayed. Entering a value from 0 to 9
followed by will specify the number of
decimal places according to the value
entered.
Ex. 3 Three decimal places
... Sci displayed. Entering a value from 0 to 9
followed by will specify the number of
significant digits from 1 to 10.
Ex. 5 5 significant digits
0 10 significant digits
... Pressing will cancel the specified number
of decimal places or the specified number of
significant digits.
* If you have not specified the number of decimal places or
the number of significant digits, you can press
and then change the range of the exponential
display. (NORM 1/NORM 2)
* With the exception of the BASE-N mode, modes ~
can be used in combination with the manual
calculation modes.
* The mode last selected is retained in memory when the
unit's power is switched off.
... Defm displayed. Entering a value followed by
will specify the number of memories available.
Ex. 10 Number of memories
available increased by 10.
M-26 S-320
S6600G-ENG-A 8/30/04, 11:05 AM Page 14-15 Adobe PageMaker 6.5C/PPC