Installation Manual of HD-TVI Speed Dome
13
power supply and a reasonable wiring route.
Get familiar with the installation environment before deploying the wire, including the wiring
distance, surrounding, and electromagnetic interference and so on.
Please choose the cable with nominal voltage higher than the actual voltage, to ensure a
normal running in case of unsteady voltage.
To protect the power cable and the signal transmitting cable from human tampering, you
should pay attention to the protection and reinforcement of the cables.
When deploying the wire, please do not tighten the wire or make the wire loose.
The wiring of the speed dome should be performed by professionals.
2.3.2
Installing the Bracket
Before you start:
Wall mounting is applicable to the indoor/outdoor solid wall construction. The followings are the
mandatory precondition for wall mounting:
The wall must be thick enough to install the expansion screws.
Please make sure that the wall is strong enough to withstand more than 8 times the weight of
the dome and the bracket.
Steps:
1.
Check whether the type of the bracket and the number of accessories are right, as shown in the
figure below.
Figure 2-14
Wall Mounting Bracket, Nuts and Flat Washers
2.
Drill 4 screw holes in the wall according to the holes of the bracket, and then insert M8
expansion screws (not supplied) into the mounting holes.
Figure 2-15
Drill Mounting Holes
3.
Attach the bracket to the wall by aligning the 4 screw holes of the bracket with expansion
screws on the wall.
4.
Secure the bracket with 4 hex nuts and washers.
