Sentiotec IS1, Инструкция по установке и эксплуатации

Страница: 24 / 116

9 Operating and display elements
Operating elements::
1
... On/off button
2
... Light
3
... + button
4
... Mode/OK button
5
... - button
Display elements:
6
... Temperature and running time display
7
... Temperature selection
8
... Running time selection
10 Rapid start
The control unit is switched on by pressing the button
1
. The current cabin temperature now appears in the
display
6
and the indicator
7
lights up.
You can now change the desired temperature with the buttons
3
and
5
. The indicator
6
flashes whilst
setting.
Confirm the temperature with the button
3
and the display
6
again shows the current cabin temperature.
Tip: If no button is activated for longer than 5 seconds, the control unit automatically adopts the target
temperature.
Now, using the button
4
, change to the time symbol
8
. You can now set the desired running time with the
buttons
3
and
5
. See also Point 11.7 in this regard.
Confirm the setting with the button
4
or wait until the control unit automatically adopts the setting. The display
6
now shows the remaining running time.
Tip: With the button
4
you can change between the symbols
7
and
8
. The display then shows the
respective actual value:
Symbol
7
: current cabin temperature
Symbol
8
: remaining running time.
Tip: the control unit stores the settings upon switch-off by pressing the button
1
. When the control unit is
switched on again with the button
1
, the last settings are called up again.
Tip: the control unit only starts when the running time is >0.
36
1 2
3
4
6
5
7
8
Fig. 10: Operating and display elements
WE DO IT FIRST.
Instructions for use for the user P. 10/14