Sentiotec IS1, Инструкция по установке и эксплуатации

Страница: 18 / 116

2 Use as intended
The IS1 infrared control unit is only suitable for use with inherently safe infrared radiators and infrared plates.
Also heed the instructions in the respective manual.
Before commissioning the control unit, the operational state of the cabin must be verified. This applies in
particular if the control unit will be started via remote start. See also the conditions in EN60335 -2-53
Suitable infrared radiators:
DIR-350-R, WIR-350-R, DIR-500-R, WIR-500-R, DIR-750-R, WIR-750-R, DIR-1300-R, WIR-1300-R
ECO-350-R, ECO-350-G, ECO-500-R, ECO-500-G, ECO-750-R
O-IRC-C, O-IRC-W
Suitable infrared plates – only in conjunction with optional film sensor XXXXX:
IR-WP-175, IR-WP-100, IR-WP-390, IR-WP-510
IR-WPHL-510, IR-WPHL-100, IR-WPHL-390, IR-WPHL-175
3 Installation instructions – only for experts
The control unit can be surface-mounted, see Chapter 3.1, or countersunk, see Chapter 3.2.
3.1 Preparation of the surface-mounting
In order to surface mount the control, cable lead-throughs must be provided in the cabin wall. The positions
can be found in the figure below.
49
85
17,5
34
49
65
80,5
1
2 3 4 5 6
7
Fig. 1 positions of cable outflows
aerial view
Fig. 2 Cable outflows
Caution - rear view
1
- Sensor cable opening;
if necessary, these can
also be guided down-
wards through the cable
shaft provided for in the
housing
7
.
Caution: if the cables
need to be guided
downwards via the
cable shaft
7
, it must
be ensured that the
sensor cables are
equipped with additio-
nal protective insulation
2
- Cable
3 - Radiator outflow
4
- Free
5
- Free
6 - Light outflow
WE DO IT FIRST.
Instructions for installation and use P. 4/14