Technical Specification & Installation
Sentinel Kinetic MVHR Installation & Commissioning
8
Installation of Unit Brackets
Stage 1:
Drill the holes according to the guide on the
previous page; make sure the holes you drill enable the
brackets to be moved apart within the guide holes on the
bracket.
Stage 2:
Place each of the
bolts into position and
do not
fully tighten. Leave approximately
“a half turn” loose on
each of the fixings. This will allow each bracket to be
moveable until final fitting of the unit and makes any
adjustments easier while installing the unit in position.
Stage 3:
The brackets are in their approximate location
and the unit can now be raised into position.
Once the unit is in its located position, the brackets can
be moved and secured.
Stage 4:
Finally, with the unit secure you can now fix the
security fixing (as pictured right).
Once secured you may proceed with the rest of the
installation.
