MA-DISP-FP4x & 6x_EN
Page 2 on 18
Rev: 08/02/2012
1.
WARNINGS
Please carefully read this manual and all warnings. Install the display ONLY when you are sure that you‟ve
covered all aspects.
Where the product is intended for “UL” installations, removal or addition of option boards is not
permitted.
Check that the model number and supply voltage suit your application before you install the
display.
Connect the display according to current IEE regulations, IEC61010 & NFPA:70 National Electric
Code in USA.
Power supplies to this equipment must have anti-surge (T) fuses rated at 1A for 230V supply, 2A
for 110V supply or 10A for DC supplies in the range 11-30VDC.
Don‟t touch any circuit try after you have connected the display, because there may be lethal
voltages on the circuit board.
Do not apply power to the display if its case is open.
Only adjust on-board switches or connections with the power turned off
Only clean the display‟s case and window with a soft damp cloth. Only lightly dampen with water.
Do not use any other solvents.
Rear case screws - please note
The rear panel is held in place with finger-screws, which only need to be
gently tightened.
Do not use tools to tighten or loosen the screws, as this could cause
damage to the internal threads.
Safety First ..............Don't assume anything............. Always double check.
If in doubt, ask someone who is QUALIFIED to assist you in the subject.
